User Manual
Table Of Contents
- NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual (802.11bgn)
- About This Manual
- Conventions, Formats and Scope
- How to Use This Manual
- How to Print this Manual
- Revision History
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Changing the Administrator Password
- Upgrading the Wireless Access Point Firmware
- Configuration File Management
- Rebooting the NETGEAR Wireless-N Access Point
- Viewing the Available Wireless Stations List
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Configuring the Advanced Wireless Settings
- Configuring the RADIUS Server Settings
- RADIUS Server Settings Fields
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Restore Factory Default Settings
- More Help
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
3-14 Wireless Security Settings
v1.0, June 2008
To configure WPA-PSK:
1. From the Configuration menu select Security and from the side menu select Security
Settings.
2. From the Network Authentication drop-down menu, select WPA-PSK. By default, Data
Encryption will be set to TKIP.
3. Enter the preshared key passphrase (Network Key).
4. Wireless Client Security Separation is disabled by default. If enabled, associated wireless
clients will not be able to communicate with each other. (This feature is intended for hotspots
and other public access situations).
5. Click Apply to save your settings.
Configuring WPA2-PSK
Not all wireless adapters support WPA2. Furthermore, client software is required on the client.
Make sure your client card supports WPA2. Consult the product document for your wireless
adapter and WPA2 client software for instructions on configuring WPA2 settings.
Figure 3-8 WPA2-PSK security settings
To configure WPA2-PSK:
1. From the Configuration menu select Security and from the side menu select Security
Settings.