User Manual

NETGEAR Wireless-N Access Point WN802Tv2 Reference Manual
3-16 Wireless Security Settings
v1.0, June 2008
To configure WPA-PSK and WPA2-PSK:
1. From the Configuration menu select Security and from the side menu select Security
Settings.
2. From the Network Authentication drop-down menu, select WPA-PSK & WPA2-PSK. By
default, Data Encryption will be set to TKIP+AES.
3. Enter the WPA Passphrase (Network Key).
4. Wireless Client Security Separation is disabled by default. If enabled, associated wireless
clients will not be able to communicate with each other. (This feature is intended for hotspots
and other public access situations).
5. Click Apply to save your settings.
Restricting Wireless Access by MAC Address
The Access Control List option lets you block the network access privilege of any specified
stations through the NETGEAR Wireless-N Access Point. When you enable access control, the
access point only accepts connections from clients on the selected access control list. This
provides an additional layer of security.
Note: When configuring the WN802Tv2 from a wireless computer whose MAC address
is not in the access control list, if you select Turn Access Control On, you will lose
your wireless connection when you click Apply. You must then access the
wireless access point from a wired computer or from a wireless computer that is
on the access control list to make any further changes.
To restrict access based on MAC addresses:
1. Log in to the WN802Tv2 using the default address of 192.168.0.233, user name of admin and
default password of password, or whatever LAN address and password you have set up (see
Figure 2-1).
2. Under the Configuration tab, select Security on the main menu, select Advanced from the
side menu, and then select Access Control List. The Access Control List screen displays.
(
Figure 3-10).