User Manual

NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100v2 User Manual
2-19
v1.0, December 2008
Wireless network name (SSID): ______________________________
• If WPA2-PSK or WPA-PSK authentication is used:
– Passphrase: ______________________________
These characters are case-sensitive.
Enter a word or group of printable characters. When you use WPA-PSK, the other devices
in the network cannot connect unless they are set to WPA-PSK as well, and are configured
with the correct passphrase.
• If WEP authentication is used:
– WEP encryption key size. Identify one: 64-bit or 128-bit. The encryption key size must
match the wireless network settings.
– Data encryption (WEP) keys. There are two methods for creating WEP data encryption
keys. Whichever method you use, record the key values in the spaces below.
• Passphrase method: ______________________________
These characters are
case-sensitive. Enter a word or group of printable characters and click the Generate
Keys button. Not all wireless devices support the passphrase method.
• Manual method. These values are not case sensitive. For 64-bit WEP, enter 10 hex
digits (any combination of 0–9 or a–f). For 128-bit WEP, enter 26 hex digits.
Key 1: _____________________________
Key 2: _____________________________
Key 3: _____________________________
Key 4: _____________________________
Setting Up WPA-PSK Security
To configure WPA-PSK security:
1. Run the WNDA3100v2 Wireless Assistant.
a. Make sure that the WNDA3100v2 software is installed and the wireless USB adapter is
fully inserted in a USB port in your computer.