User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Wireless Security Settings 3-7
v1.0, February 2009
Configuring WPA-PSK, WPA2-PSK and WPA-PSK + WPA2-
PSK
Not all wireless adapters support WPA. Furthermore, client software is required on the client.
Windows XP and Windows 2000 with Service Pack 3 or above include the client software that
supports WPA. Nevertheless, the wireless adapter hardware and driver must also support WPA.
Consult the product document for your wireless adapter and WPA client software for instructions
on configuring WPA settings.
To configure WPA-PSK, WPA2-PSK or WPA-PSK + WPA2-PSK:
1. Select WEP/WP
A Settings under the Security menu on the left navigation pane. The WEP/
WPA Settings screen will display.
Figure 3-4
2. Select one of the following radio buttons: WPA-PSK, WPA2-PSK or WPA-PSK + WPA2-
PSK. The Security encryption Passphrase field will display.