User Manual
Table Of Contents
- NETGEAR WNAP210 ProSafe Wireless-N Access Point Reference Manual
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Installation and Configuration
- Chapter 3 Wireless Security Settings
- Chapter 4 Management
- Chapter 5 Advanced Wireless Bridging
- Chapter 6 Troubleshooting
- No lights are lit on the access point.
- The Ethernet light is not lit.
- The WLAN light is not lit.
- I cannot configure the access point from a browser.
- I cannot access the Internet or the LAN with a wireless capable computer.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
Default Settings and Technical Specifications A-1
v1.0, February 2009
Appendix A
Default Settings and Technical Specifications
This appendix provides the factory default settings and technical specifications for the ProSafe
Wireless-N Access Point.
Factory Default Settings
You can use the reset button located on the front of your device to reset all settings to their factory
defaults. This is called a hard reset.
• To perform a hard reset, push and hold the reset button for approximately 5 seconds (until the
Power LED changes from blinking green to solid amber). Your device will return to the
factory configuration settings shown in
Table A-1 below.
• Pressing the reset button for a shorter period of time will simply cause your device to reboot.
Table A-1. Access Point Default Configuration Settings
Feature Description
AP Login
User Login URL 192.168.0.236 or
netgearxxxxxx”; where xxxxxx is the last 6 hexadecimal
digits of the WN802T MAC address.
User Name (case sensitive) admin
Login Password (case sensitive) password
Ethernet Connection
Access Point Name
netgearxxxxxx where xxxxxx are the last 6 digits of the
wireless access point MAC address.
Ethernet MAC Address See rear label.
Access Point Mode On
Port Speed 10/100/1000 Mbps
Local Network (LAN)