User's Manual
Table Of Contents
- NETGEAR Wireless-N 300 Router WNR2000v2 User Manual
- Contents
- Chapter 1 Configuring Basic Connectivity
- Chapter 2 Safeguarding Your Network
- Choosing Appropriate Wireless Security
- Recording Basic Wireless Settings Setup Information
- Changing Wireless Security Settings
- Viewing Advanced Wireless Settings
- Using Push 'N' Connect (Wi-Fi Protected Setup)
- Restricting Wireless Access by MAC Address
- Changing the Administrator Password
- Backing Up Your Configuration
- Understanding Your Firewall
- Chapter 3 Restricting Access From Your Network
- Chapter 4 Customizing Your Network Settings
- Chapter 5 Fine-Tuning Your Network
- Chapter 6 Using Network Monitoring Tools
- Chapter 7 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless-N 300 Router WNR2000v2 User Manual
Using Network Monitoring Tools 6-7
v1.0, September 2009
Viewing a List of Attached Devices
The Attached Devices screen contains a table of all IP devices that the router has discovered on the
local network. Select Attached Devices under Maintenance in the main menu to view the table.
For each device, the table shows the IP address, NetBIOS host name or device name (if available),
and the Ethernet MAC address. To force the router to look for attached devices, click Refresh.
Managing the Configuration File
The configuration settings of the WNR2000v2 router are stored within the router in a
configuration file. You can back up (save) this file to your computer, restore it, or reset it to the
factory default settings.
Figure 6-4
Note: If the router is rebooted, the table data is lost until the router rediscovers the
devices.