User's Manual
Table Of Contents
- Wireless-N 300 Modem Router DGN2200 User Manual
- About This Manual
- Conventions, Formats, and Scope
- Revision History
- Chapter 1 Configuring Your Internet Connection
- Chapter 2 Configuring Your Wireless Network and Security Settings
- Chapter 3 Protecting Your Network
- Chapter 4 Managing Your Network
- Chapter 5 USB Storage
- Chapter 6 Advanced Configuration
- Configuring WAN Settings
- Configuring Dynamic DNS
- Configuring LAN Settings
- Setting up Quality of Service (QoS)
- Advanced Wireless Settings
- Using Static Routes
- Configuring Universal Plug and Play
- Building Wireless Bridging and Repeating Networks
- Port Forwarding and Port Triggering
- Advanced USB Settings
- Traffic Meter
- Chapter 7 Troubleshooting
- Appendix A Wall Mounting and Technical Specifications
- Appendix B Related Documents
- Index
Wireless-N 300 Modem Router DGN2200 User Manual
Configuring Your Internet Connection 1-9
v1.0, November 2009
Configuring ADSL Settings
NETGEAR recommends that you use the Setup Wizard to automatically detect and configure your
ADSL settings. This usually works fine. However, if you have technical experience and are sure of
the multiplexing method and virtual circuit number for the virtual path identifier (VPI) and virtual
channel identifier (VCI), you can specify those settings here.
If your ISP provided you with a multiplexing method or VPI/VCI number, then enter the setting:
1. From the main menu, select ADSL Settings.The ADSL Settings screen displays.
2. In the Multiplexing Method drop-down list, select LLC-based or VC-based.
3. For the VPI, type a number between 0 and 255. The default is 8.
4. For the VCI, type a number between 32 and 65535. The default is 35.
5. Click Apply.
Note: For information about how to install ADSL filters, see the Setup Manual.
Note: NETGEAR recommends using the Setup Wizard to select the correct country to
optimize detection of the ADSL settings.
Figure 1-6