User's Manual

Wireless-N 300 Modem Router DGN2200 User Manual
Configuring Your Wireless Network and Security Settings 2-12
v1.0, November 2009
To set up basic wireless connectivity:
1. Log in to the wireless-N modem router at its default LAN address of http://192.168.0.1 with
its default user name of admin and default password of password, or using whatever LAN
address and password you have set up.
2. Select Add WPS Client (computers that will connect wirelessly to the router are clients) in the
main menu. The Add WPS Client wizard screen displays.
3. Click Next. The screen changes to allow you to select the method for adding the WPS client.
4. Select the method for adding the WPS client. A WPS client can be added using the Push
Button method or the PIN method.
• Using the Push Button. This is the preferred method. (See Figure 2-3 on page 2-12.)
– Select the Push Button radio box and either press the WPS Push Button on the side of
the wireless-N modem router or click the soft WPS Push Button on the screen (as
shown below).
– The wireless-N modem router tries to communicate with the client; you have 2
minutes to enable WPS from the client device using its WPS networking utility.
:
You can also enter either of these addresses to connect to the wireless-N modem
router: http://www.routerlogin.net or http://www.routerlogin.com.
Note: If you cannot select Add WPS Client, check to see if WPS is disabled in the
Advanced Wireless Settings screen. See “Using Static Routes” on page 6-15.
Figure 2-3