User's Manual
Table Of Contents
- Wireless-N 300 Modem Router DGN2200 User Manual
- About This Manual
- Conventions, Formats, and Scope
- Revision History
- Chapter 1 Configuring Your Internet Connection
- Chapter 2 Configuring Your Wireless Network and Security Settings
- Chapter 3 Protecting Your Network
- Chapter 4 Managing Your Network
- Chapter 5 USB Storage
- Chapter 6 Advanced Configuration
- Configuring WAN Settings
- Configuring Dynamic DNS
- Configuring LAN Settings
- Setting up Quality of Service (QoS)
- Advanced Wireless Settings
- Using Static Routes
- Configuring Universal Plug and Play
- Building Wireless Bridging and Repeating Networks
- Port Forwarding and Port Triggering
- Advanced USB Settings
- Traffic Meter
- Chapter 7 Troubleshooting
- Appendix A Wall Mounting and Technical Specifications
- Appendix B Related Documents
- Index
Wireless-N 300 Modem Router DGN2200 User Manual
6-6 Advanced Configuration
v1.0, November 2009
Configuring LAN Settings
The LAN Setup screen allows configuration of LAN IP services such as DHCP.
The wireless-N modem router is shipped preconfigured to use private IP addresses on the LAN
side, and to act as a DHCP server. The wireless-N modem router’s default LAN IP configuration is
as follows:
• LAN IP address. 192.168.0.1
• Subnet mask. 255.255.255.0
These addresses are part of the Internet Engineering Task Force (IETF)–designated private address
range for use in private networks, and should be suitable in most applications. If your network has
a requirement to use a different IP addressing scheme, you can make those changes by opening the
LAN IP Setup menu.
Under Advanced in the main menu, select LAN IP Setup.
Note: If you change the LAN IP address of the wireless-N modem router while connected
through the browser, you will be disconnected. You must then open a new
connection to the new IP address and log in again.
Figure 6-4