User's Manual
Table Of Contents
- Wireless-N 300 Modem Router DGN2200 User Manual
- About This Manual
- Conventions, Formats, and Scope
- Revision History
- Chapter 1 Configuring Your Internet Connection
- Chapter 2 Configuring Your Wireless Network and Security Settings
- Chapter 3 Protecting Your Network
- Chapter 4 Managing Your Network
- Chapter 5 USB Storage
- Chapter 6 Advanced Configuration
- Configuring WAN Settings
- Configuring Dynamic DNS
- Configuring LAN Settings
- Setting up Quality of Service (QoS)
- Advanced Wireless Settings
- Using Static Routes
- Configuring Universal Plug and Play
- Building Wireless Bridging and Repeating Networks
- Port Forwarding and Port Triggering
- Advanced USB Settings
- Traffic Meter
- Chapter 7 Troubleshooting
- Appendix A Wall Mounting and Technical Specifications
- Appendix B Related Documents
- Index
Wireless-N 300 Modem Router DGN2200 User Manual
6-22 Advanced Configuration
v1.0, November 2009
5. Verify connectivity across LAN Segment 1 and LAN Segment 2. A computer on either LAN
segment should be able to connect to the Internet or share files and printers of any other PCs or
servers connected to LAN Segment 1 or LAN Segment 2.
Multi-Point Bridge
Multi-point bridge mode allows a wireless-N modem router to bridge to multiple peer access
points simultaneously. As a bridge, wireless client associations are disabled—only wired clients
can be connected. Multi-point bridge mode configuration includes the following steps:
• Entering the MAC addresses of the other access points in the fields provided.
• Setting the other bridge-mode access points to Point-to-Point Bridge mode, using the MAC
address of this DGN2200 as the Remote MAC Address.
• Using wireless security to protect this traffic.
The following figure shows an example of a multi-point bridge mode configuration.
Figure 6-17
Internet
LAN Segment 1
PCs
PCs
Hub or switch
AP 3
AP 2
192.168.0.1
Point-to-point
bridge mode
bridge mode
Point-to-point
AP 1
DGN2200
PCs
Hub or switch
LAN Segment 3
LAN Segment 2