User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
3-1
v1.0, March 2010
Chapter 3
Configuring Security
This chapter helps you to configure the security settings on your WN604, including the new and
simple Wi-Fi Protected Setup (WPS) method. It consists of the following sections.
1. “Understanding Security Profiles”
2. “Wi-Fi Protected Setup (WPS)”
• “Configuring a client using WPS”
3. “Configuring Security Manually”
• “SSID and WEP/WPA Settings Setup Form”
• “Configuring the RADIUS Server Settings”
• “Setting up a Security Profile”
• “Configuring WEP”
• “Configuring WPA with RADIUS”
• “Configuring WPA2 with RADIUS”
• “Configuring WPA and WPA2 with RADIUS”
• “Configuring WPA-PSK”
• “Configuring WPA2-PSK”
• “Configuring WPA-PSK and WPA2-PSK”
• “Restricting Wireless Access by MAC Address”