User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
3-22
v1.0, March 2010
4. Click Apply to save your settings.
Restricting Wireless Access by MAC Address
The optional Access Control window lets you block the network access privilege of any specified
stations through the WN604 Wireless Access Point. When you enable access control, the access
point only accepts connections from clients on the selected access control list. This provides an
additional layer of security.
To restrict access based on MAC addresses:
1. Log in to the WN604 using the default address of http://192.168.0.100, user name of admin
and default password of password, or whatever LAN address and password you have set up.
2. Under the Configuration tab, select Security on the main menu, select Advanced from the
left panel, and then select MAC Authetication. The MAC Authetication screen displays.
Note: If configuring the WN604 from a wireless computer whose MAC address is not in
the access control list, if you select Turn Access Control On, you will lose your
wireless connection when you click Apply. You must then access the wireless
access point from a wired computer or from a wireless computer that is on the
access control list to make any further changes.