User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
3-23
v1.0, March 2010
3. Check the Turn Access Control On radio box to enable Access Control feature.
4. Select the desired Access Control Database options. The options are:
• Local MAC Address Database – The Access Point will use the local MAC address table
for Access Control. This is the default.
• RADIUS MAC Address Database – The Access Point will use the MAC address table
located on the external RADIUS server on the LAN for Access Control. If you choose this
database, you must configure the RADIUS Server Settings first (see “Configuring the
RADIUS Server Settings” on page 3-9).
5. The Trusted Wireless Stations list shows any wireless stations you have entered. If you have
not entered any wireless stations this list will be empty. To delete an existing entry, select it
and then click Delete.
6. Click Refresh to refresh the Available Wireless Stations list found in your area.
7. Select the stations from the list of Available Wireless Stations found in your area, or enter the
MAC address of a station to add a new station manually. (You can usually find the MAC
address printed on the bottom of the wireless adapter.)
Figure 3-16 Configure MAC authentication