User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
4-1
v1.0, March 2010
Chapter 4
Management
This chapter describes how to use the management features of your NETGEAR Wireless N150
Access Point WN604. To access these features, connect to the WN604 as described in “Logging In
Using the Default IP Address” on page 2-11. Then select the category under either the Monitoring
or Maintenance headings in the main menu of the browser interface.
This chapter contains the following sections:
1. “Upgrading the Wireless Access Point Software”
2. “Configuration File Management”
3. “Restoring the WN604 to the Factory Default Settings”
4. “Changing the Administrator Password”
5. “Enabling the SysLog Server”
6. “Using Activity Log Information”
7. “Viewing General Summary Information”
8. “Viewing Network Traffic Statistics”
9. “Viewing Available Wireless Station Statistics”
Upgrading the Wireless Access Point Software
The software of the WN604 Wireless Access Point is stored in FLASH memory, and can be
upgraded as new software is released by NETGEAR. Upgrade files can be downloaded from
Netgear's Web site.. The upgrade file can be sent to the wireless access point using your browser.
Note: The Web browser used to upload new firmware into the WN604 must support
HTTP uploads, such as Microsoft Internet Explorer 6.0 or above or Mozilla 1.5 or
above.