User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
4-4 Management
v1.0, March 2010
Restoring Saved Settings
Under the Maintenance tab on the main menu, select Upgrade, then select Restore Settings from
the sidebar to back up your current settings. The following screen displays:
1. Enter the full path to the backup file on your computer (see previous section) or click the
Browse button to locate the file.
2. When you have located the file, click Restore to upload the file. After completing the upload,
the WN604 will reboot automatically.
Restoring the WN604 to the Factory Default Settings
It is sometimes desirable to restore the wireless access point to the factory default settings. This
can be done by using the Restore Defaults option, which restores all factory settings.
To access this function:
1. Under the Maintenance tab on the main menu, select Reset, and then select Restore Defaults
from the sidebar. The Restore Defaults screen displays, as shown in Figure 4-4 below.
Figure 4-3 Restore Configuration settings from file