User's Manual
Table Of Contents
- NETGEAR Wireless N150 Access Point WN604 Reference Manual
- Contents
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Basic Installation and Configuration
- Chapter 3
- Understanding Security Profiles
- Wi-Fi Protected Setup (WPS)
- Configuring Security Manually
- SSID and WEP/WPA Settings Setup Form
- Configuring the RADIUS Server Settings
- Setting up a Security Profile
- Configuring WEP
- Configuring WPA with RADIUS
- Configuring WPA2 with RADIUS
- Configuring WPA and WPA2 with RADIUS
- Configuring WPA-PSK
- Configuring WPA2-PSK
- Configuring WPA-PSK and WPA2-PSK
- Restricting Wireless Access by MAC Address
- Chapter 4 Management
- Chapter 5 Advanced Configuration
- Chapter 6 Troubleshooting and Debugging
- No lights are lit on the wireless access point.
- The Wireless LAN activity light does not light up.
- The LAN light is not lit.
- I cannot access the Internet or the LAN with a wireless capable computer.
- I cannot connect to the WN604 to configure it.
- When I enter a URL or IP address I get a timeout error.
- Using the Reset Button to Restore Factory Default Settings
- Appendix A Default Settings and Technical Specifications
- Appendix B Related Documents
- Index
NETGEAR Wireless N150 Access Point WN604 Reference Manual
Advanced Configuration 5-5
v1.0, March 2010
Figure 5-3 shows the Quality of Service (QoS) screen. For most networks, the default QoS queue
parameter settings work well.Quality of Service provides you with the ability to specify
parameters on multiple queues for increased throughput and better performance of differentiated
wireless traffic, like Voice-over-IP (VoIP), other types of audio, video, and streaming media, as
well as traditional IP data.
To configure advanced QoS settings, on the Configuration tab select Wireless, select Advanced,
and then select QoS Settings. The QoS Settings screen dispalys:
The QoS options on the WN604 are as follows:
• AP EDCA Parameters. Specify the AP EDCA (Enhanced Distributed Channel Access)
parameters for different types of data transmitted from the WN604 Wireless Access Point
to the wireless client.
• Station EDCA Parameters. Specify the Station EDCA parameters for different types of
data transmitted from the wireless client to the WN604 Wireless Access Point. If WMM is
disabled, you cannot configure Station EDCA parameters.
Figure 5-3 Advanced QoS settings