User's Manual
Table Of Contents
- ProSafe Wireless-N Access Point WNAP320
- Contents
- 1. Introduction
- 2. Installation and Configuration
- Wireless Equipment Placement and Range Guidelines
- Understanding WNAP320 Wireless Security Options
- Installing theWireless Access Point
- Deploying the ProSafe Wireless Access Point
- Mounting the ProSafe Wireless Access Point Using the Wall Mount Kit (Optional)
- Setting Basic IP Options
- Configuring Wireless Settings
- Setting Up and Testing Basic Wireless Connectivity
- Understanding Security Profiles
- 3. Management
- Remote Management
- Remote Console
- Upgrading the Wireless Access Point Software
- Configuration File Management
- Restoring the WNAP320 to the Factory Default Settings
- Changing the Administrator Password
- Enabling the Syslog Server
- Using Activity Log Information
- Viewing General Summary Information
- Viewing Network Traffic Statistics
- Viewing Available Wireless Station Statistics
- Enabling Rogue AP Detection
- Viewing and Saving AP Lists
- 4. Advanced Configuration
- 5. Troubleshooting and Debugging
- No lights are lit on the product family.
- No lights are lit on the access point.
- The Wireless LAN LED does not light up.
- The Wireless LAN activity light does not light up.
- The Ethernet LAN LED is not lit.
- I cannot access the Internet or the LAN with a wireless-capable computer.
- I cannot connect to the WNAP320 to configure it.
- When I enter a URL or IP address, I get a time-out error.
- Using the Restore Factory Settings Button to Restore Default Settings
- A.
- A. Supplemental Information
- C. Compliance Notification
30 | Chapter 3. Management
ProSafe Wireless-N Access Point WNAP320 Reference Manual
Enabling the Syslog Server
The Syslog screen allows you to enable the syslog option if you have a syslog server on your
LAN.
To enable a syslog server:
1. Select Configuration > System > Advanced > SysLog to display the Syslog screen.
See Figure 9, .
Figure 9.
2. Enable Syslog. Enable this option if you have a syslog server on your LAN. If this feature is
enabled, you must enter the IP address of your syslog server and the port number your
SysLog server is configured to use. The default is disabled.
3. Syslog Server IP Address.The access point will send all the syslog file to the specified IP
address if syslog option is enabled. The default is 0.0.0.0.
4. Port Number. The port number configured in the syslog server on your LAN. The default is
514.
5. Click Apply to save your syslog settings.