User's Manual
Table Of Contents
- N750 Wireless Dual Band Gigabit Router WNDR4300
- Contents
- 1. Hardware Setup
- 2. Set Up Your Internet Connection
- 3. Wireless Settings
- 4. Content Filtering Settings
- 5. Network Maintenance
- 6. USB Storage
- 7. Advanced Settings
- 8. Troubleshooting
- A. Supplemental Information
- B. Notification of Compliance
- Index
Chapter 7. Advanced Settings | 71
N750 Wireless Dual Band Gigabit Router WNDR4300 User Manual
LAN Setup
The LAN Setup screen allows configuration of LAN IP services such as DHCP and Routing
Information Protocol (RIP). The router is shipped preconfigured to use private IP addresses
on the LAN side and to act as a DHCP server. The router’s default LAN IP configuration is as
follows:
• LAN IP address. 192.168.1.1
• Subnet mask. 255.255.255.0
These addresses are part of the private address range designated by the Internet
Engineering Task Force (IETF http://www.ietf.org) for use in private networks, and should be
suitable in most applications. If your network has a requirement to use a different IP
addressing scheme, you can make those changes in the LAN Setup screen.
Note: If you change the LAN IP address of the router while connected
through the browser, you are disconnected. To reconnect, open a
new connection to the new IP address and log in.
To change the LAN settings:
1. Select Advanced > LAN Setup.
The following screen displays:
2. Enter the LAN Setup configuration, and click Apply to save your changes.