User's Manual
Table Of Contents
- N300 Wireless ADSL2+ Modem Router DGN2200v4
- Contents
- 1. Hardware Setup
- 2. Getting Started with NETGEAR genie
- 3. NETGEAR genie Basic Settings
- 4. NETGEAR genie Advanced Home
- 5. USB Storage
- 6. ReadySHARE Printer
- 7. Security
- 8. Administration
- 9. Advanced Settings
- 10. Virtual Private Networking
- 11. Troubleshooting
- A. Supplemental Information
- B. VPN Configuration
- C. Notification of Compliance
145
B
B. VPN Configuration
IPSec VPN tunnel
This appendix is a case study on how to configure a secure IPSec VPN tunnel from a NETGEAR
DGN2200v4 to a FVL328. This case study follows the VPN Consortium interoperability profile
guidelines (found at http://www.vpnc.org/InteropProfiles/Interop-01.html).
Configuration Profile
The configuration in this appendix follows the addressing and configuration mechanics
defined by the VPN Consortium. Gather necessary information before you begin
configuration. Verify that the firmware is up to date, and that you have all the addresses and
parameters to be set on both sides. Check that there are no firewall restrictions.
Table 10.
VPN Consortium Scenario Scenario 1 (Identity Using Preshared Secrets)
Type of VPN LAN-to-LAN or gateway-to-gateway (not PC/client-to-gateway)
Security scheme: IKE with preshared secret/key (not certificate based)
IP addressing:
NETGEAR-Gateway A Static IP address
NETGEAR-Gateway B Static IP address
Gateway A
WAN IP
Internet
10.506.0/24
(DGN2200)
LAN IP
10.5.6.1
14.15.16.17
WAN IP
22.23.24.25
Gateway B
LAN IP
172.23.9.1
172.23.9.0/24
Figure 16. VPNC Example, Network Interface Addressing