User's Manual
Table Of Contents
- N300 Wireless ADSL2+ Modem Router DGN2200v4
- Contents
- 1. Hardware Setup
- 2. Getting Started with NETGEAR genie
- 3. NETGEAR genie Basic Settings
- 4. NETGEAR genie Advanced Home
- 5. USB Storage
- 6. ReadySHARE Printer
- 7. Security
- 8. Administration
- 9. Advanced Settings
- 10. Virtual Private Networking
- 11. Troubleshooting
- A. Supplemental Information
- B. VPN Configuration
- C. Notification of Compliance
Hardware Setup
15
N300 Wireless ADSL2+ Modem Router DGN2200v4
2. Add power to the modem router.
2
a. Connect the power adapter to the router and plug the power adapter into an outlet.
b. W
ait for the WiFi LED on the front panel to turn on. If none of the LEDs on the front
panel are on, press the On/Off button on the rear panel of the modem router.
3. Connect the computer
.
You can use an Ethernet cable or connect wirelessly.
3
• Use the yellow Ethernet cable to connect your computer to an Ethernet port on your
router.
• Or
, connect wirelessly by using the preset wireless security settings located on the
label on the bottom of the router.