User's Manual

ManualsBrandsNetgear ManualsCamera & PhotoArlo Camera

Notification of Compliance

Regulatory Compliance Information

This document includes user requirements for operating NETGEAR products in accordance with national laws

including usage of radio spectrum and operation of radio devices. Failure of the end-user to comply with the

applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable

national regulatory authority.

The NETGEAR product firmware limits operation to only the channels allowed in a particular region or country.

Therefore, all options described in this document may not be available in your version of the product.

This document applies to both Class A and Class B devices:

 Class A devices are intended to be used in a commercial or industrial environment. They are not intended

to be used in a residential home or be available for general public use.

 Class B devices are intended to be used in a residential setting, and may also be used in commercial and

industrial applications. Examples of Class B devices are telephones, personal computers, and residential

data gateways.

 Fuses should only be installed by service personnel.

 NETGEAR recommends the use of 26 AWG or larger gauge phone line cords.

Europe – EU Declaration of Conformity

This section applies to products bearing the CE or CE! mark:

Products bearing the CE or CE! mark comply with the following EU directives:

 EMC Directive 2004/108/EC

 Low Voltage Directive 2006/95/EC

 Ecodesign Directive 2009/125/EC

 RoHS Directive 2011/65/EU

If the product has telecommunications functionality, it also complies with the requirement of the following EU

directive:

 R&TTE Directive 1999/5/EC

Compliance with these directives implies conformity to harmonized European standards that are noted in the EU

Declaration of Conformity. The EU CE Declaration of Conformity may be found at

http://support.netgear.com/app/answers/detail/a_id/11621/.

Caution for installing this equipment outdoors: (Valid in all EU member states, EFTA states, and Switzerland.) Be

aware that outdoor installations require special attention and will only be handled by trained and qualified installation

personnel. No one from the general public is permitted to install NETGEAR wireless products outdoors when

external antennas, power and grounding must be installed for use. Particular attention has to be given allowed

operational frequencies. Contact NETGEAR for instructions on how to contact an installer for outdoor operations if

this product requires the special considerations for outdoor installations. For detailed iformation concerning

installations in France, the user should contact the national spectrum authority in France (http://www.arcep.fr/ )

Summary of content (16 pages)

PAGE 1
Notification of Compliance Regulatory Compliance Information This document includes user requirements for operating NETGEAR products in accordance with national laws including usage of radio spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may result in unlawful operation and adverse action against the end-user by the applicable national regulatory authority.
PAGE 2
The following paragraphs apply to WN2500RP: This device is a 2.4GHz and 5GHz wideband transmission system (transceiver), intended for indoor use only in all EU member states, EFTA states, and Switzerland. In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain authorization to use the device for setting up outdoor radio links and/or for applying public access to telecommunications and/or network services.
PAGE 3
FCC Guidelines for Human Exposure The NETGEAR product complies with FCC radiation exposure limits set forth for an uncontrolled environment. The equipment should be installed and operated with minimum distance of 20cm between the radiator and your body. The following statement applies to this product:  C6300XB3 This product complies with FCC radiation exposure limits set forth for an uncontrolled environment.
PAGE 4
NETGEAR products comply with ANSI/IEEE C95.1-1999 and are tested in accordance with the measurement methods and procedures specified in OET Bulletin 65 Supplement C. NETGEAR products that are installed in USB ports demonstrate SAR compliance using a typical laptop computer with a USB port. Other applications, such as handheld computers or similar devices, have not been verified and might not compliance with related RF exposure rule and such use is prohibited.
PAGE 5
      C6300XB3 D6000 D6010 D3600 D3610 D6200V2       HMNC100 JR6150 R6050 R6220 R7500 R8000  WNDR3400v3 The device operates in 5.15~5.25GHz frequency range. It is restricted in indoor environment only. The following statements apply to this product:    A6210 WAC120 WNDR3400v3 The device operates in 5.15 ~ 5.25GHz / 5.47 ~5.725GHz frequency range. It is restricted in indoor environment only.
PAGE 6
Canadian Department of Communications Radio Interference Regulations The information in this section applies to products bearing the statements:. “This digital apparatus does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.
PAGE 7
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée quivalente (p.i.r.e.) ne dépassepas l'intensité nécessaire à l'établissement d'une communication satisfaisante.
PAGE 8
keeping the product as far as possible from your body or by setting the device to a lower output power if such a function is available. For products available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.
PAGE 9
 WAC120 The maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the EIRP (Equivalent Isotropically Raditaed Power) limits specified for point-to-point and non point-to-point operation as appropriate. SAR warning: NETGEAR product is compliance with SAR for general population/uncontrolled exposure limits in IC RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE 1528.
PAGE 10
DFS avertissement: Sélection dynamique de fréquences (DFS) pour les dispositifs fonctionnant dans les bandes 5250-5350 MHz, 54705600 MHz et 5650-5725 MHz : Les instructions suivantes s'appliquent à ce produit:        A6210 C6300XB3 HMNC100 R8000 STS7000 WAC120 WNDR3400v3 le gain maximal d’antenne permis pour les dispositifs utilisant les bandes 5250-5350 MHz et 5470-5725 MHz doit se conformer à la limite de p.i.r.e.
PAGE 11
Class A ITE この装置は、クラス A 情報技術装置です。この装置を家庭環境で使用すると電波妨害を引き起こすことがあります。この場合には使用者が適切な対策を講ずるよう要求されることがあります。 Class B ITE この装置は、クラスB情報技術装置です。この装置は、家庭環境で使用することを目的としていますが、この装置がラジオやテレビジョン受信機に近接して使用されると、受信障害を引き起こすことがあります。取扱説明書に従って正しい取り扱いをして下さい。 Japan Wireless Notice この製品には、認証済みの無線機器を搭載しています。 South Korea Notices The information in this section applies to products bearing the KCC mark: 알림 : 대한민국으로 배송되는 제품인 경우 Class A : A급 기기 (업무용 방송통신기자재) Class B : B급 기기 (가정용 방송통신기자재) 이 기기는 업무용(A급) 전자파적합기기로서 판매자 또는 사용자는 이 점을 주의하
PAGE 12
第十四條→低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。在 5.25-5.35 秭赫頻帶內操作之無線資訊傳輸設備，限於室內使用。無線資訊傳輸設備忍受合法通信之干擾且不得干擾合法通信；如造成干擾，應立即停用，俟無干擾之虞，始得繼續使用。無線資訊傳設備的製造廠商應確保頻率穩定性，如依製造廠商使用手冊上所述正常操作，發射的信號應維持於操作頻帶中。不致造成違反低功率電波輻射性電機管理辦法之所有控制、調整及開關之使用方法對任何可能造成違反管理辦法規定之調整予以警告，或建議由具有發射機維修專長之技術人員執行或由其直接監督及負責對任何可能造成違反管理辦法之零件(晶體、半導體等)置換之警告下列聲明適用於本產品: R7500 電磁波曝露量MPE標準值1mW/cm2，送測產品實測值為：0.
PAGE 13
Australia and New Zealand Notices The information in this section applies to products bearing the Australia C-Tick and A-Tick Compulsory Marks: This device equipment complies with the Australian and New Zealand regulatory approvals requirements. Warning NETGEAR Class A products that may be utilized in domestic/residential environments may cause radio interference in which case the user may be required to take adequate measures.
PAGE 14
Alone Equal to or Less than 100Wh Figure 12 or 13 Equal to or less than 2.7 Wh=2.5 kg OR Greater than 2.
PAGE 15
Exemptions for labeling A lithium ion battery handling label is not required when a package contains not more than 2 batteries contained in the equipment. Lithium metal batteries contained in the equipment do not need any lithium battery handling label. Product disposable warning NETGEAR products must not be disposed of together with domestic waste. NETGEAR products must be disposed of at a location that is authorized to recycle electrical and electronic appliances.
PAGE 16
      Use the product only with approved equipment. Allow the products to cool before removing covers or touching internal components.