User's Manual

 C6300XB3
 HMNC100
 WNDR3400v3
 D6000
 JR6150
 D6010
 R6050
 D3600
 R6220
 D3610
 R7500
 D6200V2
 R8000
The device operates in 5.15~5.25GHz frequency range. It is restricted in indoor environment only.
The following statements apply to this product:
 A6210
 WAC120
 WNDR3400v3
The device operates in 5.15 ~ 5.25GHz / 5.47 ~5.725GHz frequency range. It is restricted in indoor environment only.
The band from 5600-5650MHz will be disabled by the software during the manufacturing and cannot be changed by
the end user. This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.
Non-DFS Warning
NETGEAR non-DFS products do not support operation in the 5600-5650MHz band. The firmware on the device
restricts the operation in this frequency band and does not utilize the channels in this band.
NETGEAR non-DFS products will not permit operations on channels 120–132 for 11a and 11n/a, which overlap the
5600–5650MHz band.
The following statements apply to these products:
 A6210
 HMNC100
 R8000
 WNDR3400v3
NETGEAR DFS products do not support operation in the 5600-5650MHz band. The firmware on the device restricts
the operation in this frequency band and does not utilize the channels in this band.
NETGEAR DFS products will not permit operations on channels 120–132 for 11a and 11n/a, which overlap the 5600–
5650MHz band.
Country Code Selection Usage (WLAN devices)
The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all
WiFi product marketed in US must fixed to US operation channels only.
TV Tuner (on Selected Models)
The information in this section applies to NETGEAR products incorporating a TV tuner.
Note to CATV System Installer: This reminder is provided to call the CATV system installer’s attention to Section 820-
93 of the National Electrical Code, which provides guidelines for proper grounding and, in particular, specifies that the
Coaxial cable shield be connected to the grounding system of the building as close to the point of cable entry as
possible.