Quick Start Manual

Installation Guide

ProSafe 100MBaseFX SFP Module AFM735

Install Your Optical Module

The 100MBaseFX SFP Module provides a full-duplex 100M bps each direction for

Ethernet operation on NETGEAR managed switches.

The switch will automatically detect the AFM735, so you can simply plug it into an

available module slot.

The module can be inserted or removed while the switch is operational.

AFM735

Installing a AFM735 Module

Insert the module firmly into the slot that supports the SFP interface. The AFM735

supports legacy 62.5/125µm OM1 multimode fiber cables up to 2km.

Removing a AFM735 Module

Release the module latch by pulling down the handle bar across the module, and pull

the module out of the module slot.

Table 1:

Technical Specifications

Standards IEEE 802.3-2002 100BaseFX

Wave Length 1310nm

Dimensions (HxWxD) 0.48" x 2.70" x 0.54"

(12.2mm x 68.56mm x 13.70mm)

Weight 0.055 lb (25g)

Operating Temperature 23 -158º F (-5 - 70ºC)

Storage Temperature -40 ~185 ºF (-40 ~ 85ºC)

Operative relative humidity 5 to 95% @ (25ºC)

Operating Distance Up to 2km for the 62.5/125µm MMF

Connectors LC

Power Consumption <1.2W

MTBF 1,587,201 Hrs(~181 years) at 25ºC

Safety Certification UL 60950-1,CSA C22.2 No. 60950-1-03

Environmental Compliance RoHS

AFM735_IG_12July10.fm Page 1 Monday, July 12, 2010 12:45 PM

PAGE 1
AFM735_IG_12July10.fm Page 1 Monday, July 12, 2010 12:45 PM Installing a AFM735 Module Installation Guide ProSafe 100MBaseFX SFP Module AFM735 e Table 1: Insert the module firmly into the slot that supports the SFP interface. The AFM735 supports legacy 62.5/125µm OM1 multimode fiber cables up to 2km. Install Your Optical Module The 100MBaseFX SFP Module provides a full-duplex 100M bps each direction for Ethernet operation on NETGEAR managed switches.
PAGE 2
AFM735_IG_12July10.fm Page 2 Monday, July 12, 2010 12:45 PM Technical Support Regulatory Compliance Thank you for selecting NETGEAR products. Statement of Conditions After installing your device, locate the serial number on the label of your product and use it to register your product at http://www.NETGEAR.com/register. Registration is required before you can use our telephone support service. Registration via our web site is strongly recommended.