Reference Manual
Table Of Contents
- Important Notice
- Safety and Hazards
- Limitation of Liability
- Patents
- Copyright
- Trademarks
- Revision History
- 1: About This Guide
- 2: AT Password Commands
- 3: Modem Status, Customization, and Reset Commands
- 4: Mobile IP Commands
- 5: SIM Commands
- 6: OMA-DM Commands
- 7: Supported GSM / WCDMA AT Commands
- 8: HSDPA / HSUPA Categories
- 9: Band Definitions
- 10: ASCII Table
- Index (AT commands)
- Index
AirCard 77Xs/34xU AT Command Reference
24 Proprietary and Confidential 4114487
Command reference
Table 4-2: Mobile IP commands
Command Description
$MIPERR
Return last MIP error code
(Sprint devices only)
Return the last MIP error code that was received by the device.
Password required: No
Usage:
• Execution: AT$MIPERR?
Purpose: Return the last MIP error code.
$QCMIP
Set/return Mobile IP state
Enable or disable Mobile IP (MIP) network authentication, or report the current state of
MIP.
Password required: No
Usage:
• Execution: AT$QCMIP=<mipValue>
Purpose: Set network authentication method to MIP or SIP.
• Query: AT$QCMIP?
Response: Returns <mipValue>
Purpose: Display the current network authentication method.
Parameters:
<mipValue> (Current mobile network authentication method)
• 0=IP disabled, Simple IP (SIP) only
• 1=MIP preferred, with SIP fallback
• 2=MIP only
$QCMIPEP
Enable/disable active profile
Enable or disable the active profile.
Note: A profile can be used only if it is active and enabled.
Password required: No
Usage:
• Execution: AT$QCMIPEP=<profileState>
Purpose: Enable or disable the currently active profile.
• Query: AT$QCMIPEP?
Response: Returns <profileState>
Purpose: Display the state of the currently active profile.
Parameters:
<profileState> (State of the currently active profile)
• 0=Disable
• 1=Enable