Quick Start Manual

ManualsBrandsNetgear ManualsWirelessNetgear ANT32405

)NSTALLATION'UIDE

ProSafe 5dB Omni-directional Indoor 3x3 Antenna ANT32405

Package Contents

• ProSafe 5dB Omni-directional Indoor 3x3 Antenna ANT32405

• Wall-mounting kit

• Installation Guide (this guide)

• Warranty/Support card

Front View

Note: For optimal results in extending wireless range with antenna installations,

consult a qualified professional installer service for a site survey and proper

installation. For a list of devices approved by the FCC for use with the antenna, see

the NETGEAR website at http://tools.netgear.com/legal/fcc_antennas.html.

Antenna Placement and Location

To maximize coverage and performance, place the antenna within the line of sight

of your wireless devices. Minimize partitions and objects that block the line of

sight if possible. The antenna can be placed on a flat surface, wall mounted, or

magnet mounted.

• If wall-mounting, place the antenna on an interior wall above cubicles

(cubicles generally include a metal foil). Ideal placement is 2 meters (6.5 feet)

high.

• If the wireless access point, router, or gateway, is in an IT room, place the

antenna outside the room against a a wall and close to the ceiling.

The area close to, behind, or beside the antenna will be covered, because the

dynamic range of the WLAN transmitter/receiver and antenna is

approximately 100 dB. Even with 20 dB to 40 dB or attenuation, the signal

strength is still strong and communication is maintained.

• The antenna has magnets in the base,

which can be used to mount it on metal

cabinets, white boards, or even the

ceiling cross bars (the framework that

holds the ceiling panels up).

Omni-directional

antenna ANT32405

Approximate

coverage area

Connecting the Antenna

Turn off your wireless access point, and connect your ANT32405 antenna. If your

wireless access point is new, follow the access point installation instructions. If you

are upgrading an existing access point, turn it on again.

ProSafe 5dB Omni-directional Indoor 3x3 Antenna ANT32405

Specifications

Frequency range 2.4~2.5GHz

Impedance 50 ohm

Gain 5dBi@ 2.45 GHz (excluding cable loss)

Cable loss can be up to 2dBi max

Operating temperature –10 to 60° C (14 to 140° F)

Storage temperature –10 to 70° C (14 to 158° F)

Humidity 95% RH

Dimensions (l x w x h) 100 x 65 x 175 mm (4 x 2.6 x 6.9 in)

Weight 237 grams (8.35 oz)

Connector Reverse N female

Warranty 2 year

Summary of content (2 pages)

PAGE 1
Antenna Placement and Location Connecting the Antenna To maximize coverage and performance, place the antenna within the line of sight of your wireless devices. Minimize partitions and objects that block the line of sight if possible. The antenna can be placed on a flat surface, wall mounted, or magnet mounted. • If wall-mounting, place the antenna on an interior wall above cubicles (cubicles generally include a metal foil). Ideal placement is 2 meters (6.5 feet) high.
PAGE 2
Radiation Patterns Statement of Conditions In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.