Installation Guide

Installation
ProSAFE® 10 Gigabit Ethernet SFP+
Module
Model AXM762
Install Your Optical Module
The 10 Gigabit small form-factor pluggable (SFP+) module provides a full-
duplex 10G bps each direction for Ethernet operation on NETGEAR managed
switches.
The switch will automatically detect the AXM762, so you can simply plug it
into an available module slot.
The module can be inserted or removed while the switch is operational.
AXM762
Technical Specifications
Standards IEEE 802.3ae 10GBase-LR
Wavelength 1310nm
Dimensions (HxWxD) 0.46” x 0.53” x 2.19”
(11.9 mm x 13.7 mm x 55.7 mm)
Weight 19.2g
Operating Temperature 32 -158º F (0 - 70ºC)
Storage Temperature 32 -185 ºF (0 - 85ºC)
Operative relative humidity 85% @ (25ºC)
Operating Distance 2m - 10km for 9/125 um SMF
Connectors LC for 9um/125um single mode cable
Power Consumption <1.5w
MTBF 4,986,536 hr (569 years)
Safety Certification UL 1950 CSA 22.2 No. 950
Environmental Compliance RoHS
Installing an AXM762 Module
Insert the module firmly into the slot that supports the SFP+ interface.
Make sure the optical cable you use is single mode LC to LC duplex cable.
Removing an AXM762 Module
Release the module latch by pulling down the handle bar across the module,
and pull the module out of the module slot.