User Manual
Table Of Contents
- Contents
- 1. Set Up and Access the Router
- 2. Specify Your Internet Settings Manually
- Use the Internet Setup Wizard
- Manually set up the router Internet connection
- Specify IPv6 Internet connections
- Requirements for entering IPv6 addresses
- Use Auto Detect for an IPv6 Internet connection
- Use Auto Config for an IPv6 Internet connection
- Set up an IPv6 6to4 tunnel Internet connection
- Set up an IPv6 6rd Internet connection
- Set up an IPv6 fixed Internet connection
- Set up an IPv6 DHCP Internet connection
- Set up an IPv6 PPPoE Internet connection
- Change the MTU size
- Set Up and Manage Dynamic DNS
- 3. Manage the Firewall and Security
- 4. Manage the LAN and VLAN Settings
- 5. Optimize Performance
- 6. Maintain the Router
- 7. Monitor the router and the router network
- 8. Set Up VPN Connections
- Set up an IPSec VPN connection
- Set up an OpenVPN connection
- Enable and configure OpenVPN on the router
- Install OpenVPN client software on a remote client
- Install the OpenVPN client utility and VPN configuration files on a Windows-based computer
- Install the OpenVPN client utility and VPN configuration files on a Mac
- Install the OpenVPN client utility and VPN configuration files on an iOS device
- Install the OpenVPN client utility and VPN configuration files on an Android device
- 9. Manage Port Forwarding and Port Triggering Traffic Rules
- 10. Troubleshooting
- A. Supplemental information
Table 2. Default Phase 1 and Phase 2 settings for IKE1 and IKE2 (Continued)
DefaultsSetting
10 secondsDPD Interval
Phase 2 settings
esp, sha1, aes256Proposal
DisabledPFS (IKE1 only)
28800 secondsSA Lifetime
For more information about these default settings, see Customize Phase 1 and Phase
2 settings for an IPSec policy on page 127.
To add an IPSec VPN policy on the router and use the default Phase 1 and Phase 2
settings:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter https://www.routerlogin.net.
Your browser might display a security message, which you can ignore. For more
information, see Log in to the local browser interface on page 16.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. If you didn’t change the password, enter password. The user name
and password are case-sensitive.
The Dashboard displays.
4. Select ADVANCED > IPSec VPN.
The IPSec VPN Policy List displays.
5. Click the Add button.
The Add Policy slide-out panel opens.
6.
In the Policy Name field, enter a name.
The name is used to identify the VPN policy and can be from 1 to 32 characters.
Note: The selection from the Mode menu is always Net-to-Net.
7.
In the Remote Gateway field, enter the IP address or domain name of the remote
VPN router.
User Manual126Set Up VPN Connections
Insight Managed Business Router BR200