User Manual
Table Of Contents
- Contents
- 1. Set Up and Access the Router
- 2. Specify Your Internet Settings Manually
- Use the Internet Setup Wizard
- Manually set up the router Internet connection
- Specify IPv6 Internet connections
- Requirements for entering IPv6 addresses
- Use Auto Detect for an IPv6 Internet connection
- Use Auto Config for an IPv6 Internet connection
- Set up an IPv6 6to4 tunnel Internet connection
- Set up an IPv6 6rd Internet connection
- Set up an IPv6 fixed Internet connection
- Set up an IPv6 DHCP Internet connection
- Set up an IPv6 PPPoE Internet connection
- Change the MTU size
- Set Up and Manage Dynamic DNS
- 3. Manage the Firewall and Security
- 4. Manage the LAN and VLAN Settings
- 5. Optimize Performance
- 6. Maintain the Router
- 7. Monitor the router and the router network
- 8. Set Up VPN Connections
- Set up an IPSec VPN connection
- Set up an OpenVPN connection
- Enable and configure OpenVPN on the router
- Install OpenVPN client software on a remote client
- Install the OpenVPN client utility and VPN configuration files on a Windows-based computer
- Install the OpenVPN client utility and VPN configuration files on a Mac
- Install the OpenVPN client utility and VPN configuration files on an iOS device
- Install the OpenVPN client utility and VPN configuration files on an Android device
- 9. Manage Port Forwarding and Port Triggering Traffic Rules
- 10. Troubleshooting
- A. Supplemental information
The Add Custom Services slide-out panel opens.
8.
Set up a new port forwarding rule for a custom service or application by specifying
the following settings:
•
Service Name. Enter the name of the custom service or application.
•
Service Type. Select the protocol (TCP or UDP) that is associated with the service
or application. If you are unsure, select TCP/UDP.
•
External port range. If the service or application uses a single port, enter the
port number in the External port range field. If the service or application uses
a range or ranges of ports, specify the range in the External port range field.
Specify one range by using a dash between the port numbers. Specify multiple
ranges by separating the ranges with commas.
•
Internal port range. Specify the internal port or ports by one of these methods:
-
If the external and internal port or ports are identical, leave the Use the same
port range for Internal port check box selected.
-
If the service or application uses a single port, clear the check box and enter
the port number in the Internal port range field.
-
If the service or application uses a range or ranges of ports, clear the check
box and specify the range in the Internal port range field. Specify one range
by using a dash between the port numbers. Specify multiple ranges by
separating the ranges with commas.
•
Internal IP address. Either enter an IP address in the Internal IP address field
or select the radio button for an attached device that is listed in the table.
9. Click the Apply button.
Your settings are saved. The rule is added to the table on the Port Forwarding / Port
Triggering page.
Change a port forwarding rule
You can change an existing port forwarding rule.
To change a port forwarding rule:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter https://www.routerlogin.net.
Your browser might display a security message, which you can ignore. For more
information, see Log in to the local browser interface on page 16.
User Manual143Manage Port Forwarding and
Port Triggering Traffic Rules
Insight Managed Business Router BR200