User Manual
Table Of Contents
- Contents
- 1. Set Up and Access the Router
- 2. Specify Your Internet Settings Manually
- Use the Internet Setup Wizard
- Manually set up the router Internet connection
- Specify IPv6 Internet connections
- Requirements for entering IPv6 addresses
- Use Auto Detect for an IPv6 Internet connection
- Use Auto Config for an IPv6 Internet connection
- Set up an IPv6 6to4 tunnel Internet connection
- Set up an IPv6 6rd Internet connection
- Set up an IPv6 fixed Internet connection
- Set up an IPv6 DHCP Internet connection
- Set up an IPv6 PPPoE Internet connection
- Change the MTU size
- Set Up and Manage Dynamic DNS
- 3. Manage the Firewall and Security
- 4. Manage the LAN and VLAN Settings
- 5. Optimize Performance
- 6. Maintain the Router
- 7. Monitor the router and the router network
- 8. Set Up VPN Connections
- Set up an IPSec VPN connection
- Set up an OpenVPN connection
- Enable and configure OpenVPN on the router
- Install OpenVPN client software on a remote client
- Install the OpenVPN client utility and VPN configuration files on a Windows-based computer
- Install the OpenVPN client utility and VPN configuration files on a Mac
- Install the OpenVPN client utility and VPN configuration files on an iOS device
- Install the OpenVPN client utility and VPN configuration files on an Android device
- 9. Manage Port Forwarding and Port Triggering Traffic Rules
- 10. Troubleshooting
- A. Supplemental information
2
Specify Your Internet Settings
Manually
Usually, the quickest way to set up the Internet connection is to allow the NETGEAR
installation assistant to detect the Internet connection when you first set up and access
the router with a web browser. You can also customize or specify your Internet settings
manually
This chapter contains the following sections:
• Use the Internet Setup Wizard
• Manually set up the router Internet connection
• Specify IPv6 Internet connections
• Change the MTU size
• Set Up and Manage Dynamic DNS
20