User Manual
Table Of Contents
- Contents
- 1. Set Up and Access the Router
- 2. Specify Your Internet Settings Manually
- Use the Internet Setup Wizard
- Manually set up the router Internet connection
- Specify IPv6 Internet connections
- Requirements for entering IPv6 addresses
- Use Auto Detect for an IPv6 Internet connection
- Use Auto Config for an IPv6 Internet connection
- Set up an IPv6 6to4 tunnel Internet connection
- Set up an IPv6 6rd Internet connection
- Set up an IPv6 fixed Internet connection
- Set up an IPv6 DHCP Internet connection
- Set up an IPv6 PPPoE Internet connection
- Change the MTU size
- Set Up and Manage Dynamic DNS
- 3. Manage the Firewall and Security
- 4. Manage the LAN and VLAN Settings
- 5. Optimize Performance
- 6. Maintain the Router
- 7. Monitor the router and the router network
- 8. Set Up VPN Connections
- Set up an IPSec VPN connection
- Set up an OpenVPN connection
- Enable and configure OpenVPN on the router
- Install OpenVPN client software on a remote client
- Install the OpenVPN client utility and VPN configuration files on a Windows-based computer
- Install the OpenVPN client utility and VPN configuration files on a Mac
- Install the OpenVPN client utility and VPN configuration files on an iOS device
- Install the OpenVPN client utility and VPN configuration files on an Android device
- 9. Manage Port Forwarding and Port Triggering Traffic Rules
- 10. Troubleshooting
- A. Supplemental information
3. Enter the router user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. If you didn’t change the password, enter password. The user name
and password are case-sensitive.
The Dashboard displays.
4. Select ADVANCED > Firewall > Access Control.
The Access Control page displays.
5. Select the Turn on Access Control check box.
You must select this check box before you can specify an access rule and use the
Allow and Block buttons. When the Turn on Access Control check box is cleared,
all devices are allowed to connect, even if a device is in the list of blocked devices.
6. Click the Apply button.
Your settings are saved.
7.
Select an access rule for new devices:
•
Allow all new devices to connect. With this setting, if you add a new device, it
can access your network. You do not need to enter its MAC address on this page.
We recommend that you leave this radio button selected.
•
Block all new devices from connecting. With this setting, if you add a new device,
before it can access your network, you must enter its MAC address in the allowed
list. For more information, see Manage network access control lists on page 52.
The access rule does not affect previously blocked or allowed devices. It applies
only to devices joining your network in the future after you apply these settings.
8.
To manage access for currently connected computers and devices, do the following:
a.
If you blocked all new devices, you can allow the computer or device that you
are currently using to continue to access the network. Select the check box next
to your computer or device in the table, and click the Allow button.
b.
To change the allow or block settings for other computers and devices, select
the check box next to the computer or device in the table, and click either the
Allow button or the Block button.
9. Click the Apply button.
Your settings are saved.
User Manual51Manage the Firewall and
Security
Insight Managed Business Router BR200