User Manual
Table Of Contents
- Contents
- 1. Set Up and Access the Router
- 2. Specify Your Internet Settings Manually
- Use the Internet Setup Wizard
- Manually set up the router Internet connection
- Specify IPv6 Internet connections
- Requirements for entering IPv6 addresses
- Use Auto Detect for an IPv6 Internet connection
- Use Auto Config for an IPv6 Internet connection
- Set up an IPv6 6to4 tunnel Internet connection
- Set up an IPv6 6rd Internet connection
- Set up an IPv6 fixed Internet connection
- Set up an IPv6 DHCP Internet connection
- Set up an IPv6 PPPoE Internet connection
- Change the MTU size
- Set Up and Manage Dynamic DNS
- 3. Manage the Firewall and Security
- 4. Manage the LAN and VLAN Settings
- 5. Optimize Performance
- 6. Maintain the Router
- 7. Monitor the router and the router network
- 8. Set Up VPN Connections
- Set up an IPSec VPN connection
- Set up an OpenVPN connection
- Enable and configure OpenVPN on the router
- Install OpenVPN client software on a remote client
- Install the OpenVPN client utility and VPN configuration files on a Windows-based computer
- Install the OpenVPN client utility and VPN configuration files on a Mac
- Install the OpenVPN client utility and VPN configuration files on an iOS device
- Install the OpenVPN client utility and VPN configuration files on an Android device
- 9. Manage Port Forwarding and Port Triggering Traffic Rules
- 10. Troubleshooting
- A. Supplemental information
6.
To add a device to the allowed list, do the following:
a. Click the Add button.
The Add Allowed Device slide-out panel opens.
b.
Enter the MAC address and device name for the device that you want to allow.
c. In the Add Allowed Device slide-out panel, click the Apply button.
The device is added to the allowed list on the Access Control page.
7.
To remove a device from the allowed list, do the following:
a.
Select the check box for the device.
b. Click the Delete button.
The device is removed from the allowed list.
8. Click the Apply button.
Your settings are saved.
Add a device to or remove it from the blocked list
If you set up an access list that allows all new devices to access your network but you
want to block some devices, you must specify the devices that you want to block.
To add or remove a device that is blocked:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter https://www.routerlogin.net.
Your browser might display a security message, which you can ignore. For more
information, see Log in to the local browser interface on page 16.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. If you didn’t change the password, enter password. The user name
and password are case-sensitive.
The Dashboard displays.
4. Select ADVANCED > Firewall > Access Control.
The Access Control page displays.
5.
Click the View list of blocked devices not currently connected to the network
link.
User Manual53Manage the Firewall and
Security
Insight Managed Business Router BR200