User Manual
Table Of Contents
- Contents
- 1. Set Up and Access the Router
- 2. Specify Your Internet Settings Manually
- Use the Internet Setup Wizard
- Manually set up the router Internet connection
- Specify IPv6 Internet connections
- Requirements for entering IPv6 addresses
- Use Auto Detect for an IPv6 Internet connection
- Use Auto Config for an IPv6 Internet connection
- Set up an IPv6 6to4 tunnel Internet connection
- Set up an IPv6 6rd Internet connection
- Set up an IPv6 fixed Internet connection
- Set up an IPv6 DHCP Internet connection
- Set up an IPv6 PPPoE Internet connection
- Change the MTU size
- Set Up and Manage Dynamic DNS
- 3. Manage the Firewall and Security
- 4. Manage the LAN and VLAN Settings
- 5. Optimize Performance
- 6. Maintain the Router
- 7. Monitor the router and the router network
- 8. Set Up VPN Connections
- Set up an IPSec VPN connection
- Set up an OpenVPN connection
- Enable and configure OpenVPN on the router
- Install OpenVPN client software on a remote client
- Install the OpenVPN client utility and VPN configuration files on a Windows-based computer
- Install the OpenVPN client utility and VPN configuration files on a Mac
- Install the OpenVPN client utility and VPN configuration files on an iOS device
- Install the OpenVPN client utility and VPN configuration files on an Android device
- 9. Manage Port Forwarding and Port Triggering Traffic Rules
- 10. Troubleshooting
- A. Supplemental information
6. Click the Add button.
The Add Services Blocking slide-out panel opens.
7. From the Service Type menu, select the service or application to be covered by this
rule.
The Protocol, Starting Port, and Ending Port fields are automatically populated
when you select the service or application.
Note: If the service or application does not display in the list, you can add it by
selecting User Defined from the Service Type menu (see Add a service blocking
rule for a custom service or application on page 59).
8.
Specify which devices on your LAN are affected by the rule, based on their IP
addresses:
•
Only This IP Address. Enter the required IP address in the fields to apply the rule
to a single device on your LAN.
•
IP Address Range. Enter the required start and end IP addresses in the fields to
apply the rule to a range of devices.
• All IP Addresses. All computers and devices on your LAN are covered by this
rule.
By default, the All IP Addresses radio button is selected.
9. Click the Add button.
The new rule is added to the Service Table on the Block Services page.
Add a service blocking rule for a custom service or
application
If the service or application is not predefined, you can add a service blocking rule for a
custom service or application.
To add service blocking rule for a custom service or application:
1.
Find out which protocol and port number or range of numbers the service or
application uses.
You can usually find this information by contacting the publisher of the service or
application or through online user or news groups.
2.
Launch a web browser from a computer or mobile device that is connected to the
router network.
3.
Enter https://www.routerlogin.net.
User Manual59Manage the Firewall and
Security
Insight Managed Business Router BR200