User Manual
Table Of Contents
- Contents
- 1. Set Up and Access the Router
- 2. Specify Your Internet Settings Manually
- Use the Internet Setup Wizard
- Manually set up the router Internet connection
- Specify IPv6 Internet connections
- Requirements for entering IPv6 addresses
- Use Auto Detect for an IPv6 Internet connection
- Use Auto Config for an IPv6 Internet connection
- Set up an IPv6 6to4 tunnel Internet connection
- Set up an IPv6 6rd Internet connection
- Set up an IPv6 fixed Internet connection
- Set up an IPv6 DHCP Internet connection
- Set up an IPv6 PPPoE Internet connection
- Change the MTU size
- Set Up and Manage Dynamic DNS
- 3. Manage the Firewall and Security
- 4. Manage the LAN and VLAN Settings
- 5. Optimize Performance
- 6. Maintain the Router
- 7. Monitor the router and the router network
- 8. Set Up VPN Connections
- Set up an IPSec VPN connection
- Set up an OpenVPN connection
- Enable and configure OpenVPN on the router
- Install OpenVPN client software on a remote client
- Install the OpenVPN client utility and VPN configuration files on a Windows-based computer
- Install the OpenVPN client utility and VPN configuration files on a Mac
- Install the OpenVPN client utility and VPN configuration files on an iOS device
- Install the OpenVPN client utility and VPN configuration files on an Android device
- 9. Manage Port Forwarding and Port Triggering Traffic Rules
- 10. Troubleshooting
- A. Supplemental information
•
Your company’s network address is 134.177.0.0.
When you first configured your router, two implicit static routes were created. A default
route was created with your ISP as the gateway and a second static route was created
to your local network for all 192.168.1.x addresses. With this configuration, if you attempt
to access a device on the 134.177.0.0 network, your router forwards your request to
the ISP. The ISP forwards your request to the company where you are employed, and
the request is likely to be denied by the company’s firewall.
In this case, you must define a static route, instructing your router that 134.177.0.0 is
accessed through the ISDN router at 192.168.1.100. Here is an example:
•
Through the destination IP address and IP subnet mask, specify that this static route
applies to all 134.177.x.x addresses.
•
Through the gateway IP address, specify that all traffic for these addresses is
forwarded to the ISDN router at 192.168.1.100.
•
A metric value of 1 works fine because the ISDN router is on the LAN.
Add an IPv4 static route
You can add an IPv4 static route to a destination IP address and specify the subnet mask,
gateway IP address, and metric.
To add an IPv4 static route:
1.
Launch a web browser from a computer or mobile device that is connected to the
router network.
2.
Enter https://www.routerlogin.net.
Your browser might display a security message, which you can ignore. For more
information, see Log in to the local browser interface on page 16.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. If you didn’t change the password, enter password. The user name
and password are case-sensitive.
The Dashboard displays.
4. Select ADVANCED > Static Routes.
The Static Routes page displays.
5. Click the Add button.
The Add IP Static Route slide-out panel opens.
User Manual87Manage the LAN and VLAN
Settings
Insight Managed Business Router BR200