User Manual

Nighthawk AC1900 WiFi Cable Modem Router
Specify Internet Port Settings User Manual111
•Any (the default) allows any computer on the Internet to use this service.
• Single address restricts the service to a particular computer.
9. Select the service type, either TCP or UDP or TCP/UDP (both).
If you are not sure, select TCP/UDP.
10. In the Triggering Starting Port, enter the beginning port number.
11. In the Triggering Ending Port field, enter the ending port number.
12. Enter the inbound connection port information in the Connection Type, Starting Port, and
Ending Port fields.
13. Click the Apply button.
The service is now in the Portmap table. You must enable port triggering before the
modem router used port triggering for the service that you added. See the following
section.
Application Example: Port Triggering for Internet Relay
Chat
Some application servers, such as FTP and IRC servers, send replies to multiple port
numbers. Using port triggering, you can tell the modem router to open more incoming ports
when a particular outgoing port starts a session.
An example is Internet Relay Chat (IRC). Your computer connects to an IRC server at
destination port 6667. The IRC server not only responds to your originating source port, but
also sends an “identify” message to your computer on port 113. Using port triggering, you can
tell the modem router, “When you initiate a session with destination port 6667, you must also
allow incoming traffic on port 113 to reach the originating computer.” The following sequence
shows the effects of this port triggering rule:
1. You open an IRC client program to start a chat session on your computer.
2. Your IRC client composes a request message to an IRC server using a destination port
number of 6667, the standard port number for an IRC server process. Your computer then
sends this request message to your modem router.
3. Your modem router creates an entry in its internal session table describing this
communication session between your computer and the IRC server. Your modem router
stores the original information, performs Network Address Translation (NAT) on the source
address and port, and sends this request message through the Internet to the IRC server.
4. Noting your port triggering rule and observing the destination port number of 6667, your
modem router creates another session entry to send any incoming port 113 traffic to your
computer.
5. The IRC server sends a return message to your modem router using the NAT-assigned
source port (for example, port 33333) as the destination port. The IRC server also sends an
“identify” message to your modem router with destination port 113.
6. When your modem router receives the incoming message to destination port 33333, it
checks its session table to see if a session is active for port number 33333. Finding an active