User's Manual
Table Of Contents
- Reference Manual for the Model CG814W Wireless Cable Modem Gateway
- Contents
- About This Manual
- Chapter 1 Introduction 1-1
- Chapter 2 Connecting the Gateway to the Internet 2-1
- Chapter 3 Wireless Configuration 3-1
- Chapter 4 Protecting Your Network 4-1
- Chapter 5 Managing Your Network 5-1
- Chapter 6 Troubleshooting 6-1
- Appendix A Technical Specifications A-1
- Appendix B Networks, Routing, and Firewall Basics B-1
- Appendix C Preparing Your Network C-1
- Glossary G-1
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Gateway to the Internet
- Chapter 3 Wireless Configuration
- Chapter 4 Protecting Your Network
- Chapter 5 Managing Your Network
- Chapter 6 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Networks, Routing, and Firewall Basics
- Related Publications
- Basic Router Concepts
- Internet Security and Firewalls
- Wireless Networking Overview
- Authentication and WEP
- Wireless Channels
- Ethernet Cabling
- Appendix C Preparing Your Network
- Glossary
Reference Manual for the Model CG814W Wireless Cable Modem Gateway
Preparing Your Network C-11
DHCP Configuration of TCP/IP in Windows 2000
Once again, after you have installed the network card, TCP/IP for Windows 2000 is configured.
TCP/IP should be added by default and set to DHCP without your having to configure it.
However, if there are problems, you may need to know how to do it manually. Remember, Cox
only sets up TCP/IP dynamically, (i.e., it uses DHCP to obtain TCP/IP settings). Following are the
steps to configure TCP/IP with DHCP for Windows 2000.
Verify that the Obtain an IP address
automatically radio button is selected.
• Verify that Obtain DNS server address
automatically radio button is selected.
• Click the OK button.
This completes the DHCP configuration of
TCP/IP in Windows XP.
Repeat these steps for each PC with this
version of Windows on your network.