User's Manual
Table Of Contents
- Reference Manual for the Model CG814W Wireless Cable Modem Gateway
- Contents
- About This Manual
- Chapter 1 Introduction 1-1
- Chapter 2 Connecting the Gateway to the Internet 2-1
- Chapter 3 Wireless Configuration 3-1
- Chapter 4 Protecting Your Network 4-1
- Chapter 5 Managing Your Network 5-1
- Chapter 6 Troubleshooting 6-1
- Appendix A Technical Specifications A-1
- Appendix B Networks, Routing, and Firewall Basics B-1
- Appendix C Preparing Your Network C-1
- Glossary G-1
- About This Manual
- Chapter 1 Introduction
- Chapter 2 Connecting the Gateway to the Internet
- Chapter 3 Wireless Configuration
- Chapter 4 Protecting Your Network
- Chapter 5 Managing Your Network
- Chapter 6 Troubleshooting
- Appendix A Technical Specifications
- Appendix B Networks, Routing, and Firewall Basics
- Related Publications
- Basic Router Concepts
- Internet Security and Firewalls
- Wireless Networking Overview
- Authentication and WEP
- Wireless Channels
- Ethernet Cabling
- Appendix C Preparing Your Network
- Glossary
Reference Manual for the Model CG814W Wireless Cable Modem Gateway
C-14 Preparing Your Network
DHCP Configuration of TCP/IP in Windows NT4
Once you have installed the network card, you need to configure the TCP/IP environment for
Windows NT 4.0. Again, remember Cox only sets up TCP/IP dynamically (i.e., it uses DHCP to
obtain TCP/IP settings).
Following are the procedures you use to configure TCP/IP with DHCP in Windows NT 4.0.
• Choose Settings from the Start Menu, and then select Control Panel.
This will display Control Panel window.
• Double-click the Network icon in the
Control Panel window.
The Network panel will display.
• Select the Protocols tab to continue.