Quick Reference Guide

Reference Manual for the Model DG814 DSL Modem Internet Gateway
6-2 Maintenance
The System Status screen shows the parameters listed in Table 6-1
Table 6-1. System Status fields
Field Description
System Name This field displays the Host Name assigned to the router.
Router Firmware Version This field displays the router firmware version.
WAN Port These parameters apply to the Internet (WAN) port of the router.
IP Address This field displays the IP address being used by the Internet (WAN) port
of the router. If no address is shown, the router cannot connect to the
Internet.
IP Subnet Mask This field displays the IP Subnet Mask being used by the Internet (WAN)
port of the router.
DHCP If set to None, the router is configured to use a fixed IP address on the
WAN or to use PPPoE or PPPoA.
If set to Client, the router is configured to obtain an IP address
dynamically from the ISP.
LAN Port These parameters apply to the Local (LAN) port of the router.
IP Address This field displays the IP address being used by the Local (LAN) port of
the router. The default is 192.168.0.1
IP Subnet Mask This field displays the IP Subnet Mask being used by the Local (LAN)
port of the router. The default is 255.255.255.0
DHCP If set to None, the router will not assign IP addresses to local PCs on the
LAN.
If set to Server, the router is configured to assign IP addresses to local
PCs on the LAN.
ADSL Firmware Version This field displays the ADSL chipset firmware version.
Modem Status This field displays the state of the ADSL connection to your service
provider, either “Connecting” or “Connected”
Connect Mode This field displays the protocol used to connect to your service provider.
When the ADSL link comes up, the connection will be either “Fast” or
“Interleaved”, depending on the way the telephone company has
configured its equipment
Down Stream This field displays the connection rate in from the service provider to the
router in bits per second
Up Stream This field displays the connection rate in from the router to the service
provider in bits per second
VPI This field displays the VPI entered in the WIZARD SETUP
VCI This field displays the VCI entered in the WIZARD SETUP