Operation Manual

Access the Modem Router

N300 Wireless ADSL2+ Modem Router DGN2200v4

NETGEAR genie Setup

NETGEAR genie runs on any device with a web browser. Installation and basic setup takes

about 15 minutes to complete.

 To use NETGEAR genie to set up your modem router:

1. T

urn on the modem router by pressing the On/Off button.

2. Make sure that your computer or wireless device is connected to the modem router with an

Ethernet cable (wired) or wirelessly with the preset security settings listed on the bottom

label.

3. Launch your Internet browser

• The first time you set up the Internet connection for your modem router, the browser

goes to http://www

.routerlogin.net, and the NETGEAR genie screen displays.

• If you already used the NETGEAR genie, type http://www.routerlogin.net in the

address field for your browser to display the NETGEAR genie screen. See Use

NETGEAR genie after Installation on page 18.

4. Follow the onscreen instructions to complete NETGEAR genie setup.

NETGEAR genie guides you through connecting the modem router to the Internet.

If the browser cannot display the web page:

• Make sure that the computer is connected to one of the four LAN Ethernet ports or

wirelessly to the modem router.

• Make sure that the modem router has full power

, and that its WiFi LED is lit.

• T

o make sure that the browser does not cache the previous page, close and reopen the

browser.

• Browse to http://www

.routerlogin.net.

• If the computer is set to a static or fixed IP address (this is uncommon), change it to

obtain an IP address automatically from the modem router.