Owner's Manual

VPN Configuration
152
N300 Wireless ADSL2+ Modem Router DGN2200v3
The resulting screen should show Update OK: good:
4. Configure the DGN2200v3 as in the gateway-to-gateway procedures using the VPN Wizard
(see Set Up a Gateway-to-Gateway VPN Configuration on p
age 117), being certain to use
appropriate network addresses for the environment.
The LAN addresses used in this example are as follows:
Device LAN IP Address LAN Subnet Mask
DGN2200v3 10.5.6.1 255.255.255.0
FVL328 172.23.6.1 255.255.255.0
a. Enter toFVL328 for the connection name.
b. Enter fvl3
28.dyndns.org for the remote WAN's IP address.
c. Enter the
following:
• IP Addr
ess: 172.23.9.1
• Subn
et Mask: 255.255.255.0
5. Configu
re the FVL328 as in the gateway-to-gateway procedures for the VPN Wizard (see
Set Up a Gateway-to-Gateway VPN Configuration on p
age 117), being certain to use
appropriate network addresses for the environment.
a. Enter toDG834 fo
r the connection name.
b. Enter dg8
34g.dyndns.org for the remote WAN's IP address.
c. Enter the
following:
• IP Addr
ess: 10.5.6.1
• Subn
et Mask: 255.255.255.0
6. T
est the VPN tunnel by pinging the remote network from a PC attached to the DGN2200v3.
a. Op
en the command prompt (Start -> Run -> cmd)