User's Manual

NETGEAR VPN Configuration
166
N600 Wireless Dual Band Gigabit ADSL2+ Modem Router DGND3700
The LAN addresses used in this example are as follows:
Table 26.
Device LAN IP Address LAN Subnet Mask
DGND3700 10.5.6.1 255.255.255.0
FVL328 172.23.6.1 255.255.255.0
a. For the connection name, enter toFVL328.
b. For the remote WAN's IP address, enter fvl328.dyndns.
org.
c. Enter the f
ollowing:
• IP Address. 172.23.9.1
• Subnet Mask. 255.255.255
.0
5. Configure the FVL328 as in the gateway-to-gateway procedures for the VPN Wizard (see
Set Up a Gateway-to
-Gateway VPN Configuration on page 101), being cert
ain to use
appropriate network addresses for the environment.
a. For the connection name, enter toDGND3
300v2.
b. For the remote WAN's IP address, enter dgnd3300v2.dy
ndns.org.
c. Enter the f
ollowing:
• IP Address. 10.5.6.1
• Subnet Mask. 255.255.255
.0
6. Test the VPN tunnel by pinging the remote network from a PC attached to the N600
Wireless Dual Ba
nd Gigabit ADSL2+ Modem Router DGND3700.
a. Open the command prompt (select St
art > Run > cmd)
b. Type ping 172.23.9.
1.
If the pings fail the first time, try the pings a second time.
Configuration Summary (Telecommuter Example)
The configuration in this section follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather the necessary information before you begin configuration.