User Manual

Model EA101 USB Ethernet Adapter Installation Guide
1. Using a UTP cable, connect any port on the hub to the RJ-45 port on
the adapter.
2. Follow the illustration below to connect the network cables.
Note: One of the ports on NETGEAR hubs is switchable between
Normal (MDI-X) and Uplink (MDI) with a Normal/Uplink push
button. If you are using this switchable port on a NETGEAR hub to
connect to a PC, a network card, or to the Model EA101 USB Ethernet
adapter, make sure the Normal/Uplink push button is set to Normal.
Connect the Network Adapter and Cables
Power adapter
PC with network
card installed
Category 5 10/100 Mbps UTP cables*
*Use the cables provided or any Category 5 UTP cable.
Maximum length = 100 meters (300 feet)
PC with USB port
USB
connector
Model EA101 USB
Ethernet Adapter
Hub
9310FA