Quick Reference Guide

Reference Manual for the Model FR114P, FR114W and FM114P Cable/DSL ProSafe Firewall
Setting Up the Hardware 2-3
The Firewall’s Front Panel
The front panel of the NETGEAR ProSafe Firewall contains status LEDs. The FR114P front panel
is shown in Figure 2-1
Figure 2-1. FR114P Front Panel
You can use some of the LEDs to verify connections. Table 2-1 lists and describes each LED on
the front panel of the firewall. These LEDs are green when lit, except for the TEST LED, which is
amber.
Table 2-1. LED Descriptions
Label Activity Description
POWER On Power is supplied to the firewall.
TEST On
Off
The system is initializing.
The system is ready and running.
PRINTER (These LEDs present only on FR114P and FM114P)
ACT Blinking Data is being transmitted or received by the Printer port.
ALERT On (Amber) The connected printer is offline, is out of paper, or has a paper
jam.
INTERNET
100 (100 Mbps) On
Off
The Internet (WAN) port is operating at 100 Mbps.
The Internet (WAN) port is operating at 10 Mbps.
LINK/ACT
(Link/Activity)
On
Blinking
The Internet port has detected a link with an attached device.
Data is being transmitted or received by the Internet port.
LOCAL
100 (100 Mbps) On
Off
The Local port is operating at 100 Mbps.
The Local port is operating at 10 Mbps.
LINK/ACT
(Link/Activity)
On
Blinking
The Local port has detected a link with an attached device.
Data is being transmitted or received by the Local port.
WLAN On The Wireless (WLAN) port is operating (FR114W and FM114P)