NETGEAR, Inc.
Start Here Package Contents The NETGEAR® Model FS516 16-Port Fast Ethernet Switch and Model FS524 24-Port Fast Ethernet Switch provide you with a lowcost, high-performance network solution and are designed to support power workgroups operating at either 10 megabits per second (Mbps) or 100 Mbps.
LEDs 1 The table below describes the activity of the LEDs. Label Color Activity Description Power Green Rx/Tx/ Collision Green On Off Blinking Power is supplied to the hub. Power is disconnected. Packet transmission or reception is occurring on the port. The blinking action corresponds to the number of packets that are transmitted or received. Data collision is occurring on the port. The blinking corresponds to the number of collisions.
2. Connect one end of the AC power cord cable to the power outlet on the rear panel of the switch and the other end of the AC power cord to the wall outlet. RJ-45 Connector The RJ-45 connector (shown in the illustration with an RJ-45 plug) is used to connect workstations, hubs, and switches through unshielded twisted pair cable. The RJ-45 connector accepts four-pair Category 3 (10 Mbps) or Category 5(100 Mbps) UTP cable.
Technical Specifications General Specifications Model FS516 Fast Ethernet Switch Network Protocol and Standards compatibility Model FS524 Fast Ethernet Switch ISO/IEC 802-3 (ANSI/IEEE 802.3i) 10BASE-T Ethernet IEEE 802.
