Owner's Manual

Firewall Protection
129
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
WAN Users The settings that determine which Internet locations are covered
by the rule, based on their IP address. The options are:
• Any. All Internet IP address are covered by this rule.
• Si
ngle address. Enter the required address in the Start field.
• Address range. Enter the required addresses the Start and
Finish fields.
LAN WAN rules
D
MZ WAN rules
DMZ Users The settings that determine which DMZ computers on the DMZ
network are affected by this rule. The options are:
• Any. Al
l computers and devices on your DMZ network.
• Single address. En
ter the required address in the Start field to
apply the rule to a single computer on the DMZ network.
• Addre
ss range. Enter the required addresses in the Start and
Finish fields to apply the rule to a range of DMZ computers.
DMZ WAN rules
LAN DMZ rules
QoS Priority The priority assigned to IP packets of this service. The priorities
are defined by Type of Service (ToS) in the Internet Protocol Suite
standards, RFC 1349. The QoS profile determines the priority of
a service, which, in turn, determines the quality of that service for
the traffic passing through the firewall.
The wireless VPN firewall marks the Type of Service (ToS) field
as defined in the QoS profiles that you create. For more
information, see Preconfigured Quality of Service Profiles on
page 173.
Note: The wireless VPN firewall has preconfigured default QoS
profile
s; you cannot configure the QoS profiles. A QoS profile can
become active only when you apply it to a nonblocking inbound
or outbound firewall rule.
LAN WAN rules
DMZ WAN rules
Bandwidth Profile Bandwidth limiting determines the way in which the data is sent to
and from your host. The purpose of bandwidth limiting is to
provide a solution for limiting the outgoing and incoming traffic,
thus preventing the LAN users from consuming all the bandwidth
of the Internet link. For more information, see Create Bandwidth
Profiles on page 171. For outbound traffic, you can configure
bandwidth limiting only on the WAN interface for a LAN WAN rule.
Note: Bandwidth limiting does not apply to the DMZ interface.
IPv4 LAN WAN rules
Table 32. Outbound rules overview (continued)
Setting Description Outbound Rules