Quick Reference Guide

NETGEAR VPN Configuration of FVS318 or FVM318 to FVL328 E-1
M-10146-01
Appendix E
NETGEAR VPN Configuration
of FVS318 or FVM318 to FVL328
This appendix is a case study on how to configure a secure IPSec VPN tunnel from a NETGEAR
FVS318 or FVM318 to a FVL328. This case study follows the VPN Consortium interoperability
profile guidelines (found at http://www.vpnc.org/InteropProfiles/Interop-01.html). The
configuration options and screens for the FVS318 and FVM318 are the same.
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table E-1. Profile Summary
VPN Consortium Scenario: Scenario 1
Type of VPN LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
Security Scheme: IKE with Preshared Secret/Key (not Certificate-based)
Date Tested: April 2003
Model/Firmware Tested:
NETGEAR-Gateway A FVS318 firmware version A1.4 or FVM318 firmware version 1.1
NETGEAR-Gateway B FVL328 with firmware version 1.4 Release 1A
IP Addressing:
NETGEAR-Gateway A Static IP address
NETGEAR-Gateway B Static IP address