Quick Reference Guide

ProSafe VPN Firewall FVS318v3 Reference Manual

Basic Virtual Private Networking 4-21

v5.0, January 2012

Setting Up a Gateway-to-Gateway VPN Configuration

Figure 4-22

Follow the procedure below to set the LAN IPs on each FVS318v3 to different subnets and

configure each properly for the Internet.

The LAN IP address ranges of each VPN endpoint must be different. The connection will fail if

both are using the NETGEAR default address range of 192.168.0.x.

In this example, LAN A uses 192.168.0.1 and LAN B uses 192.168.3.1.

To configure a gateway-to-gateway VPN tunnel using the VPN Wizard:

1. Log in to the FVS318v3 on LAN A at its default LAN address of http://192.168.0.1 with its

default user name of

admin and password of password. Click the VPN Wizard link in the

main menu to display this screen. Click Next to proceed.

Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC

default parameters listed in Table 4-1 on page -4. If you have special

requirements not covered by these VPNC-recommended parameters, refer to

Chapter 5, “Advanced Virtual Private Networking” to set up the VPN tunnel.

VPN Tunnel

PCs

FVS318v3 VPN Firewall