Quick Reference Guide

ProSafe VPN Firewall 200 FVX538 Reference Manual
Introduction 1-7
v1.0, January 2010
3,
WAN Ports and
LEDs
(continued)
Active
LED
On (Green) The WAN port has a valid Internet connection.
On (Amber) The Internet connection is down or not being used
because the port is available for failover in case the
connection on other WAN port fails.
Off The WAN port is either not enabled or has no link.
4.
LAN Ports and
LEDs
8-port RJ-45 10/100 Mbps Fast Ethernet Switch N-way automatic speed negotiation,
auto MDI/MDIX.
Link/Act
LED
On (Green) The LAN port has detected a link with a connected
Ethernet device.
Blinking (Green) Data is being transmitted or received by the LAN port.
Off The LAN port has no link.
100 LED
On (Green) The LAN port is operating at 100 Mbps.
Off The LAN port is operating at 10 Mbps.
DMZ LED
(port 8)
On (Green) Port 8 is operating as a dedicated hardware DMZ port.
Off Port 8 is operating as a normal LAN port.
5.
Gigabit Port and
LEDs
Gbit RJ-45 connector. Port for connecting to a Gigabit Ethernet device.
Link/Act
LED
On (Green) The LAN port has detected a link with a connected
Ethernet device.
Blinking (Green) Data is being transmitted or received by the LAN port.
Off The LAN port has no link.
Speed
LED
On (Green) The LAN port is operating at 1,000 Mbps.
On (Amber) The LAN port is operating at 100 Mbps.
Off The LAN port is operating at 10 Mbps.
6.
Console Port
DB9 male connector.
Port for connecting to an optional console terminal. Default baud rate is 115.2K; pinouts:
(2) Tx, (3) Rx, (5) and (7) Gnd.
7.
Factory Defaults
Push in with a sharp object
Factory Defaults reset push button (see Appendix A, “Default Settings and Technical
Specifications” for the factory defaults).
Table 1-1. Object Descriptions (continued)
Object LED Activity Description