User's Manual Part 2
Table Of Contents
- Chapter 7 Print Server
- Chapter 8 Virtual Private Networking
- Overview of FWG114P Policy-Based VPN Configuration
- Using Digital Certificates for IKE Auto-Policy Authentication
- Walk-Through of Configuration Scenarios on the FWG114P
- How to Use the VPN Wizard to Configure a VPN Tunnel
- Netgear VPN Client to FWG114P
- Step-By-Step Configuration of FWG114P Gateway
- Step-By-Step Configuration of the Netgear VPN Client
Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P
Print Server 7-3
March 2004, 202-10027-01
Complete the Add Standard TCP/IP Printer
Port Wizard.
a. Click Next to proceed with the Add
Standard TCP/IP Printer Port Wizard.
The Add Port screen will display.
b. From the Add Port screen, enter
192.168.0.1, the FWG114P default LAN
IP address, in the IP Address field.
Note: If you changed the default LAN IP
Address of the FWG114P, be sure to use
the address you assigned here. The Port
Name is automatically filled in.
Click Next to proceed.
c. In the Device Type section of the
Additional Port Information Required
screen, select Custom.
d. In the Custom selection, click Settings.
e. The Port Settings tab page opens. In the
Protocol section, select the LPR radio
button, and enter FWG114P as the
Queue Name in the LPR Settings
section. Click OK to close this tab page.
Click Next to proceed.
The Add Printer Wizard will now
prompt you to install the software for the
printer you attached to the FWG114P.
Add Standard TCP/IP Printer Port Wizard
Add Port Screen
Additional Port Information Required
Additional Port Information Required