GS105PE Quick Installation Guide

Installation Guide

ProSAFE Plus 5-Port Gigabit PoE Pass Through

Switch GS105PE

Step 2. Connect power.

Step 3. Check status.

PoE pass through

enabled

Off

Power LED

Step 1. Connect equipment.

GS105PE switch

Computer Server

PoE Switch

PoE pass through

disabled

1000 Mbps activity

(blinking)

No link (off)

1000 Mbps link

Port LEDs Left

10/100 Mbps link

10/100 Mbps activity

(blinking)

PoE PD (Port 5)

LED Right

PoE PSE (Ports 1

and 2) LEDs Right

Receiving power

from PSE per 802.3at

specification

Receiving power

from PSE

Off

Supplying power

PoE Fault

No PoE Power

PD not deteced

GS105PE switch

PoE Switch

PoE PD Port PoE PSE Port

PAGE 1
Installation Guide ProSAFE Plus 5-Port Gigabit PoE Pass Through Switch GS105PE Step 2. Connect power. Step 3. Check status. Power LED Step 1. Connect equipment. Computer PoE pass through enabled PoE pass through disabled Server GS105PE switch Port LEDs Left 1000 Mbps link 10/100 Mbps link 1000 Mbps activity (blinking) Off PoE Switch 10/100 Mbps activity (blinking) No link (off) PoE PD Port PoE PSE Port PoE PD (Port 5) LED Right Receiving power from PSE per 802.
PAGE 2
Set Up the Switch Configuration Utility PoE Pass Through Plus switches are plug and play. You can install a configuration utility to select additional options to manage and customize the switch for your network. This utility is on the resource CD that was shipped with the switch. This switch supports PoE pass through. When the power LED is blinking green, it means PoE pass-through is disabled because the input voltage to port 5 is less than 45 VDC.