GS108PEv3 Quick Installation Guide

Installation

Step 1. Connect the equipment.

ProSAFE Plus 8-Port Gigabit Switch with

4-Port PoE

GS108PEv3

Step 2. Connect to power. Step 3. Check the status.

Power LED Right PoE LEDs (Ports 1–4) Le Port LEDs (Ports 1–8)

On PoE in use 1000 Mbps

link

O PoE halted 10/100 Mbps

No PoE use (o )

Activity

(blinking)

No link (o )

PoE Max. LED

Less than 7W of PoE power is available.

PoE Max. LED was activated in the previous two minutes

(blinking).

PoE ports are working normally (o ).

GS108PEv3 Optional router

Optional modem

IP Phone Server

Internet

PAGE 1
Installation ProSAFE Plus 8-Port Gigabit Switch with 4-Port PoE Step 2. Connect to power. Step 3. Check the status. GS108PEv3 Power LED Step 1. Connect the equipment. IP Phone Server Right PoE LEDs (Ports 1–4) Left Port LEDs (Ports 1–8) On PoE in use 1000 Mbps link Off PoE halted 10/100 Mbps Internet No PoE use (off ) Activity (blinking) No link (off ) Optional modem PoE Max. LED Less than 7W of PoE power is available. PoE Max. LED was activated in the previous two minutes (blinking).
PAGE 2
Set Up the Switch Conﬁguration Utility Plus switches are plug and play. You can install a conﬁguration utility to select additional options to manage and customize the switch for your network. This utility is on the resource CD that was shipped with the switch. Note: The conﬁguration utility is installed on your computer and is supported only on Windows.  To install the conﬁguration utility: 1. Insert the resource CD into a computer that is connected to the switch. 2.